Factory Outlet Pollution Monitoring Devices Detector Aqm System For So2 No2 O3 Co Test

Factory-Outlet Air Quality Pollution Monitor Detector Aqm System For So2 No2 O3 Co Test Environmental Monitoring Devices

Porduct Introduction:

Customizable to customer needs, provides a strong data base for the grid platform, and can be calibrated on site to ensure traceability.
Monitoring parameters: standard pollutants ozone (O3), nitrogen dioxide (NO2), nitrogen oxide (NOx), carbon monoxide (CO), sulfur dioxide (SO2), particulate matter (PM10, PM2.5);Other pollutants of particular concern: volatile organic compounds (VOC), hydrogen sulfide (H2S), carbon dioxide (CO2);And noise, temperature, humidity, wind speed, wind direction, air pressure, etc.

Apply to industry:

• Urban residential areas, key industrial enterprises and other fixed pollution sources of regional environmental monitoring
• Unorganized environmental monitoring of open space for road traffic, catering, agricultural production, etc
• Monitoring of boundary transport of key pollution sources
• Monitoring of intercity pollutant transport channels
• Indoor environment monitoring such as building

Technical parameters:

Gas monitoring parameters (NO2, CO, SO2, O3) :
Working voltage: DC5V±1%/DC24V±1%
Response time: < 30S
Principle of detection: electrochemistry
NO2 measurement range/resolution: 0-1/0.001 PPM
CO measurement range/resolution: 0-200/0.1ppm
SO2 measurement range/resolution: 0-1/0.001 PPM
Range/resolution of O3 measurement: 0-1/0.001 PPM
Sampling accuracy: ±2%FS
Working humidity: 10 ~ 95%RH(non-condensation)
Repeatability: ±1%FS
Long-term drift: ≤1%FS/ year
Operating temperature: -20 ~ 70℃
Storage temperature: -40 ~ 70℃
Warm-up time: 30S
Working pressure: 86kPa ~ 106kPa
Working current: ≤50mA warranty period for one year
Service life: 2 years aluminum alloy shell material
Output signal: 4-20mA (rs232/485 can be supported)

PM2.5, PM10 monitoring equipment parameters
Principle of measurement: Principle of light scattering (optical particle size cutting without physical particle size cutter)
Particle size monitoring: PM2.5, PM10
Sampling flow rate: 1L/min
Concentration range: 0-40 mg/m3
Monitoring accuracy: 1 ug/m3
Reproducibility: ≤±2%
Accuracy: ≤±10%
Sampling period: 1 minute (1-999 seconds settable)
Operating temperature: -5-50℃
Storage temperature: -20-50℃
Gas sampling flow rate: 0-5L/min (electronic adjustment)
Dust sampling flow rate: 0-20L/min
Sampling method: pumping type